batte melt pump

The Problem that Weightless Feeder Can't Start with Heavy Load

For the problem that weightlessness feeder cant start with heavy load, there are three ways to solve it. First, to reduce the impact of ore on weightlessness feeder, the traditional method is to reduce the inclination of the back wall of silo through experiments according to the specific conditions of each unit, but this method will make the material slide slowly and have adverse effects on production, so as not to affect production on the one hand, and on the other hand, to reduce the impact of

Leading Characteristics and Workflow of Weightlessness Feeder

Losin weight feeder leading features: common parameters can be set in the weighing process while checking the variety number, actual weight of the first scale and various accumulations; control functions such as feeding, secondary or tertiary feeding, bag clamping, bag patting and batch setting; various output functions can be optionally selected by the spare output port; reliable parameters after debugging can be stored and debugged. Number and recovery of factory parameters; 26 channels of swi

Operating Rules for Single Screw Volume Feeder

1. Carefully implement the relevant provisions of the General Operational Regulations for Mechanized Transportation Equipment. 2. Carefully implement the following supplementary provisions: (1) Before work, we should conscientiously do the following: 1. Inspection of wire rope and pulley shall be in good condition without wire breakage, strand breakage and serious wear and tear. 2. Turn on the rotary mechanism to align the feeder with the cupola charging inlet of the on-duty production. 3. In th

Lubrication and maintenance of loss in weight feeder

Lubrication and maintenance of loss in weight feeder loss in weight feeder lubrication: If the feeder is lubricated with butter, the refueling amount is 1/3 to 1/2 of the bearing (no more than the center line of the bearing), and each bearing is roughly the same. After 400 hours of operation, the feeder opens the hexagonal screw under the exciter, discharges the dirty oil in the pipe and refuels it. If lubricating oil is used, it is necessary to keep the oil level in the tubing slightly below th

Analysis of reasons for vacuum feeder not sucking material

The long-term use of vacuum feeder may lead to the problem of non-suction of the machine. Now as equipment management personnel, timely troubleshooting of the equipment, so as to ensure the normal operation of the equipment. There are many reasons for the failure of non-suction, and managers can check it mainly from the following aspects. 1. Check control system. Check whether there are any problems on the touch screen of the vacuum suction machine control system, check whether the parameters ar



©2019 Batte Mechanical Zhengzhou Co,.Ltd. All rights reserved. sales@battemachinery.com
Batte is a professional screen changer manufacturer, supplying screen changer, especially screen changer for extrusion mould